Skip to Content
📄 Orqa FPV.Ctrl Radio

Orqa FPV.Ctrl Radio


Download the Mobile App


This app makes binding and managing drone connections simple in the classroom, allowing for great a high degree of control and customizability. Download the Orqa FPV.Ctrl App for IOS or Android


Binding to your Receiver

• Open the Orqa FPV.Ctrl App

• Turn on the Orqa FPV.Ctrl Radio

• Select the device underneath Available Controllers and select Connect

• Select Ghost Menu

• Press the text that reads Bind, then on the secondary menu press Bind + Setup… 

• Change the radio protocol to SBUS

• Connect a battery to the drone, the first time you do this the receiver will automatically enter bind mode. There is no need to press the button as in old receivers.

• On the App, press Start Bind


Calibrate your Radio Gimbals:

Open the Orqa FPV.Ctrl App

Turn on the Orqa FPV.Ctrl Radio

Select the device underneath Available Controllers and select Connect

Select About & Settings, choose Calibration

Go through the steps as indicated to position the gimbals according to the animation. You will have only few seconds per position. 

Connect to Betaflight and verify on the Receiver tab that the drone is responding appropriately. 

The minimum values should be 1000, middle value 1500, maximum 2000

Ensure the simulated drone is not rotating with the radio gimbals at rest.


Reduce Radio Transmitter Power:
Open the Orqa FPV.Ctrl App

Turn on the Orqa FPV.Ctrl Radio

Select the device underneath Available Controllers and select Connect

Select Ghost Menu, then Tx Power

Set Mode to Manual

Set Power to 16uW (16 microwatts)


Adjusting Betaflight
Modes Tab - Adjust AUX and Range Settings for:

Arm - Left Locking Press Button (Aux 1)

Flip Over After Crash - Right Press Button (Aux 3)

Beeper - Right Press Button (Aux 3)

Leaving Angle Mode on Aux 8 with the entire Range selected